The Essential Laws of Explained

Useful Tips for How to Replace a Cutlass Bearing

A cutlass bearing is a bearing on a vessel’s drive shaft log that is commonly made using brass and a lining that is grooved from the inside which is lubricated by the water which enters the grooves during rotation, this.

Regardless of the times when your boat is used, you must change the cutlass bearing in the long run. As soon as you realize it is time to make the cutlass bearing change you may find it hidden in the woodwork of the boat or some distance away from the keel.

Fortunately apart from getting your hands dirty, removing the cutlass bearing is not tricky. Keep reading this article to know how to replace a cutlass bearing, now.

Locating and removing the set screws should be the first thing to do. In most cases, the screws are found hidden under a thin marine layer of crud and growth. Not all boat manufacturers use the set screws. If you already know that your boat does not have set screws, then it is not good to waste time looking for them.

Of course you will have to cut the bearing. You can cut the cutlass bearing using a hacksaw if you don’t have a Sawzall from Propeller Depot with you. You must have enough knowledge of how to use the Sawzall tool from Propeller Depot.

Bending the cutlass bearing is the next step. You can bend the cutlass bearing to the inner side using a cold chisel and a hammer so that you reach the other side where you have made a cut. Do not use excessive force when hitting the cutlass bearing for it to bend. If you force it you will damage the strut of the boat.

Insert a maple dowel after creating a space from bending the cutlass bearing on the boat to the inside and using a hammer slit it open to the other end. Do not use metal tools to slit open the cutlass bearing up to its length. If you do so, you risk damaging the inside of the strut.

To conclude, remove the cutlass bearing. To remove the cutlass bearing use a pair of pliers to hold. Now clean the surface of the strut and install a new cutlass bearing. After you remove the old cutlass bearing, cleaning the surface of the strut, and want to install a new cutlass bearing bought from Propeller Depot, make sure enter the acme props in a straight line.

If the ramrod strut is forced and not straight it, you may damage it. So that the ramrod of the strut can go in straight use some grease on the cutlass bearing to help it to slide in easily.

Advanced reading: More hints